2000D Series Curtain Wall and 2000HP Series Curtain Wall
Structural aluminum mesh curtain wall for commercial applications
HP – superior thermal performance such as pool environments
Extruded aluminum curtain wall in 6063-T6 alloy minimum and 6061-T6 for unexposed structural elements. Usually used for low-rise building facades.
All seals are made of SILICONE or EPDM depending on their location and function in the system.
Insulated Glass Unit (IGU) options: 25mm (1”), 32mm (1 ¼”), 38mm (1 ½”).
The IGUs are installed from the outside with dried gaskets and can be held by pressure plates or by structural silicone.
Also available with high thermal performance pressure plates (MR200HP) for location with high-relative humidity.
Available frame depths :
- 5mm x 44.5 (2 ½’’ x 1 ¾’’)
- 5mm x 76.2 (2 ½’’ x 3’’)
- 5mm x 114.3 (2 ½’’ x 4 ½’’)
- 5mm x 139.7 (2 ½’’ x 5 ½’’)
- 5mm x 174.6 (2 ½’’ x 6 7/8’’)
- 5mm x 228.6 (2 ½’’ x 9’’)
Several aesthetic caps and features are available to enhance the building design.
Technical performance
Primary product designation :
Curtain Wall
(not covered by NAFS standards)
Air infiltration/exfiltration :
FIXED Level: Maximum 0,2 l/s-m2 @ 300 Pa
In accordance with ASTM-E283-04
Water resistance test :
No water infiltration at 700 Pa
In accordance with AAMA/WDMA/CSA 101/i.S.2/A-440-11, ASTM-E547, ASTM-E547
Uniform load deflexion :
Deflexion limited to L/175 at the pressure determined by the current code
In accordance with AAMA/WDMA/CSA 101/i.S.2/A-440-11, ASTM-E330-02
Forced entry resistance :
Grade 00
In accordance with AAMA/WDMA/CSA 101/i.S.2/A-440-11 (9.3.5), ASTM-F588-07
U-value in accordance with NFRC 100.
–
